T hat's right this card has water in it! Such a fun effect my Grandkids love this card! This is my third card using the Whale of A Time Suite!
Card Base and Cuts: DSP = Designer Series Paper
Card Base: Granny Apple Green - 5 1/2 x 8 1/2 scored at 4 1/4
Layer 1 – Whale of a Time DSP - 4 x 5 1/2
Layer 2 – Whisper White – 3 ½ x 3 ½
Layer 3 – Whisper White – 3 ¼ x 5
Layer 4 – Whisper White – Circle from Layer 2
Layer 5 - Whisper White - 4 x 5 ¼
Layer 6 – Whisper White – 1 ½ x 1 ½
Layer 1 – Using the Largest Circle from the Layering circle Dies cut a circle about 3/8" from top edge.
Wrap Ribbon around bottom about ½” from bottom using Mini Glue Dots on the back side.
Layer 2 – Using the Layering Circle Dies (The Largest and 3rd largest) cut out a circle frame.
Set aside the Circle for your Layer 4.
Sponge frame with Granny Apple Green ink.
Then set inside of the circle in Layer 1 and tape in place on the back with scotch tape.
Using a 3 x 4 3/4 clear zip lock plastic bag, place onto back of Layer 1 as shown.
(Note: You will want the bottom of the bag to be even with the bottom of the circle frame this will leave a good portion of the bag off the top edge).
Next Using the Foam Adhesive Strips cut 4 strips at 3 1/4" long. Form a frame around the bag.
Caution: DO NOT TAPE DOWN THE BAG!
Adhere another foam strip at the bottom about 1/4" from the bottom edge. Set aside.
Layer 3 – Using Sponge Daubers and Granny Apple Green, Pool Party and Just Jade ink blend colors together onto the top section down about 3 ½”. (Lightest to darkest)
Using Night of Navy ink stamp a few of the fish images and the air bubbles.
Layer 4 – Stamp the Whale image in Pacific Point Ink then punch out with the Whale Punch.
Lay Layer 1 over Layer 3 (Do not adhere) making sure to center and bottom edge about 1/8" longer then Layer 3.
Add Liquid glue to back of Whale and place in middle of circle onto Layer 3.
Remove Layer 1 turn over and pull of the covering from the Foam adhesive strips.
Then lay Layer 3 onto Adhesive Strips. Leaving space at the top for another Foam Adhesive strip.
Fill the zip lock plastic bag with about ¼ teaspoon of water and the Whale of a time sequin.
Seal bag about 3/4 of the way across then lay on table and carefully push out all air.
Once all the air is out seal completely. ****VERY IMPORTANT MAKE SURE THE BAG IS SEALED ALL THE WAY!****
To check for any leaks lay on a table carefully and apply a bit of pressure and move around. There should not be any wet spots.
Then slip bag down between layers 1 & 3.
Fold top of bag over Layer 3 and tape in the back. .
Place another Foam Adhesive strip across the back top of layer 1.
Adhere Tear and Tape to the back of layer 3 remove backing from this and the Foam adhesive strip at the top.
Then adhere to the card front.
Layer 5 - Stamp Sentiment, turtle and fish in Pacific Point ink then adhere to inside of card.
Layer 6 – Stamp sentiment in Pacific Point. Fussy cut then with Stampin Dimensionals adhere to the card front as shown.