Tags To Go Enjoy Travel

{ tams # 94648 }

Print Recipe

Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- card from Shy Shamrock Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Shy Shamrock Cardstock
- 3" x 4" from Basic Black Cardstock
- 2-7/8" x 3-7/8" of various travel images on light green background design from On The Go 12" x 12" Designer Series Paper, cut so the image are vertical on the vertical rectangle
- 3/4" x 3" from Basic White Cardstock

Insert the Shy Shamrock rectangle into the Forever Plaid 3D Embossing Folder. Use the line printed on the front flap of the folder to make sure it is lined up straight. Place the folder with the cardstock inside on the platform on your Stampin' Cut & Emboss Machine and run through the machine.

Adhere the dry embossed Shy Shamrock rectangle to the front of the Shy Shamrock card.

Adhere the piece of On The Go Designer Paper to the center of the Basic Black rectangle and then to the center of the card front.

Unlock the Happy Labels Pick A Punch. Slide one short edge of the white strip into the left side of the punch (the side of the punch with the larger scallops) as far as it will go and get it centered. Punch. Repeat on the other end.

Mount the "enjoy!" sentiment from the Tags To Go Set on Block B. Ink it up with the Shy Shamrock Ink Pad. Stamp it in the center of the punched white strip at a slight angle. Stamp it two more times on either side of the first sentiment at slightly different angles. Remember to re-ink the stamp each time.

Adhere the stamped sentiment strip to the card front as shown so it is centered over the matted designer paper strip near the top.

Cut a 20" piece of black twine included in the Baker's Twine Essentials Pack. Fold the twine in half. Tie a small bow in the center of the folded twine. Trim the ends.

Use a Mini Glue Dot to adhere the twine bow to the front of the card as shown so it is centered over the right edge of the matted designer paper just below the sentiment strip.